Once everything is ready youĬan install the head gasket onto the engine block by aligning the alignment dowels. Locations, typically this means putting the #1 piston to TDC or Top Dead Center. Much the same you have to set the pistons to their correct To set the camshafts to their correct positions to prevent any valves from hitting pistons during installationĪnd torquing of the head bolts. The first thing you must do when installing cylinder heads is to ensure both the block and head surfaces areĬompletely clean from dust, oil, and any debris. To ensure all pistons move smoothly in and out of their cylinders and nothing binds.įocus 2.0L SOHC Connecting Rod Torque Specs : 29 ft-lbs Once installed you can match the connecting rod caps with the correct rods and start to torque the connecting Or mark is facing the front of the engine and that you don't scratch the cylinder. The piston can now be lowered into the cylinder, make sure the dot Once the rings have been installed you can now fit the connecting rod bearings into the end capsĪnd lube them up with oil or lithium grease. Each ring manufacturer is different so be sure to check for your The instructions given with the new rings. Positions, this can be determined by looking at Make sure to put the correct rings in the correct
Not to stretch the rings or break them during installation. To install the pistons and connecting rods you must first install the piston rings into each piston.
0 kommentar(er)
